Natural
Gas Generator Sets
Two (2) used Caterpillar G3516 Natural Gas fueled 1400 Kw induction
generator
sets. These units were part of a pilot program to evaluate the potential
of converting
natural gas electricity by connecting to the 25,000 volt three phase
distribution
system - Gensets and step-up transformer and switchgear included.
The generator packages consist of the following units and components:
Caterpillar G3516B natural gas generators built in 2003.
Engine Power: 1818 HP
Fuel gas pressure: 1.5 - 5.0 psig
Ignition System: Adem 3
Engine speed: 1800 rpm
Min. methane number: 80
NOx emission level: 1.0 g/bhp-hr
Fuel consumption: 6863 BTU/bhp-hr
Extreme application, 14 inch inlet/outlet grade silencer, GT exhaust
Crank case exhaust evacuator
24 bolt DC starters
PLC based pre & post lube DC
Block heaters
Generator
US Motors 1400 Kw, 4160 volt induction generator, 3 phase, 60 hz
Complete with sleeve bearings
Insulation: Class F
Class B temperature rise, (80 Deg. C. Rise for normal output)
Heaters: 2 RTDs per phase:
Cooler:
40 deg. C
480 volt, 3 phase, TEFC electric motor low noise fan tip blades induced
draft
with vertical exhaust complete with man-door access.
Skid enclosure:
sound attenuated building, 30% perf liner mineral wood sound insulation.
16 feet W x 32 feet L x 12 feet H, complete with a acoustically treated
air intakes,
air exhaust, cooler exhaust. Skid base 55 feet long.
Generators all have independent high voltage switch gear room isolated
from engine generator room.
Devices:
Allen Bradley PLC processor SLC500
Fuel flow computer meter
HMI; touch screen, colour display
Rosemount temperature transmitters
Radio modem, 330-512
Switchgear:
4160 volt, distribution line up, includes, utility motor disconnect,
station
service TX feed, Transistion cell, soft starter, and cap bank with
controls.
Charger battery, 120 v DC/AC
Converter DC/DC 12 volt to 24 volt.
Electrical Engineering: Cat G3516B motor hours
|
Looking for something completely different? We'll find it.
Call or email.
 |
