Cardwell L 350

Cardwell L–350
6000 to 10,000 Feet Capacity

Draw Works:
Cardwell-Model L-350, Lebus grooving 1 1/8”drilling line, make up and
breakout catheads, 15” double McKinny hydromatic, 2-engine compound powered
by two Caterpillar 3406, 0 hour, 435 HP engines, Quincy 325 air-compressor.

Derrick and Substructure:
Lee C. Moore (Refurbished) 114’, Crown, racking board, standpipe, tong
counter weights (350,000 SHL est.),
Box on Box 15’x 16’ x 41’ with rotary beams and air tanks with 4 sets of
stairs

Mud Pumps:
2-National K-700A’s (Rebuilt) with pulsation dampeners, pop-off valves, and
4”
mud valves, powered by Caterpillar D-379 (Rebuilt), 0 hours.

Mud Tanks:
Two 400 BBL pits, 7’ x 10’ x 40’, with 2 cone Desander, 10 cone Desilter,
single linear motion shaker, 4-mud agitators, mud jets and dump valves,
three 5” x 6” centrifugal pumps with 60 HP electric motors, hand rails.

Generator House:
Generator house with 300 KW generators powered by Caterpillar 3406s,
2-Castis screw air compressors 125 CFM x 150 PSI.

Rotary Table & Kelly:
Oilwell 17 ˝ x 44” Rotary Table; 5 Ľ” x 40’ Hex Kelly with Kelly spinner.

Traveling Block:
Sowa 150 Ton Block/Hook Combo (Rebuilt).

Swivel:
Brewster, 150 Ton.

Top Dog House:
Top Doghouse 32’ x 8’ x 8’, with lockers, knowledge box, and benches.

Fuel Tank:
10,000 gallon, with dual fuel pump and filters.

Water Tank:
500 BBL.

Accumulator:
5 station, closing unit, new.

Choke Manifold:
3000#, 4 valve, with twin choke.

BOP Stack:
Shaffer 3000# (Rebuilt) Type E, Double.

Drill Pipe:
9,500 feet, 4”, 14.40# with IF connections.

Drill Collars:
20, 6 ˝” Slick Drill Collars.

Pipe Handling Tools:
1 set BJ Rotary Tongs, DC slips, drill pipe slips, drill pipe elevator
safety clamps, rotary tong and pump gauges, bottom hole bit subs,
surface bit subs, 10-DC handling subs with 4”, X-hole IF connections.

Instrumentation:
Satellite, auto driller, Martin Decker weight indictor, Crown Automatic.

Drill Line:
5,000 ft, 1 1/8” drill line.

Pipe Racks & Cat Walk:
4’ x 50’ catwalk, 6 pipe racks.

Tool Pusher’s Office & Quarters:
14’X 45’X 8’, with office, and living quarters.

Crew Quarters & Change House:
Crew Quarters House 14’ x 55’ x 8’, 12 bunks with lounge, kitchen, etc.
One 8’ x
10’ x 8’ rig toilet with shower, toilet, urinal, sink and bench.

Fork Lift
Caterpillar 8,000# capacity with extend a boom, 4x4 wheel drive