NITROGEN
UNITS 180K
Available
(4)
Manufacturer:
Cryomec
Rate:
180,000 scf / hr.
Nitrogen
Pump: Chemical Seal
& Packing
Model ISP 200
Frame:
Aluminum
Engine:
6 cylinder Detroit
Condition
of units: need refurbishing
Refurbishing
details: AMBIENT REFURBISHING
and HEAT RECOVERY
REFURBISHING are detailed below.
Pricing
and terms are detailed below.
SCOPE
OF WORK TO BE PERFORMED FOR AMBIENT 130K
The
output for 1.50 cold end .0272 for 3 cylinders
.0272
x 900 rpm = 24.48 GPM for 3-cylinders at 85% efficiency.
24.48
GPM x 93.11 SCF per GPM = 2279 SCFM.
2279
SCFM x 60 = 136.740 SCFH
Some
of the gauges are usable or repairable and some need to be
replaced. Some of
the valves are usable or repairable and some need to be
replaced. N2 suction plumbing is repairable and useable.
N2 discharge plumbing is repairable and useable.
The gear box drive is repairable and useable.
New
Cold Ends 1.50
New
Boos Pump and Hydraulic Motor
New
Hydrostatic pump 5,000 psi
New
hydrostatic motor 5,000 psi
New
hydraulic hoses and fittings 5,000 psi
Prime
and paint (No Sand Blasting)
SCOPE
OF WORK TO BE PERFORMED FOR HEAT RECOVERY 180K
The
ambient units can be converted to heat recovery units which will
consist of :
In-Frame
8V92 TA Engine
New
180K SCFH @ 10,000 PSI WP pot vaporizor heat exchanger with
1" autoclave connections.
New
180K SCFH 10,000 PSI WP exhaust gas heat exchanger with 1"
autoclave connections
New
Mission water pump 2 x 1-1/2
New
hydraulic water tube type heat exchanger
New
relief valves for back PsI and to build heat
New
relief valves for PSI
New
remote control valves mounted in panel for hyd psi and heat
control
New
hydraulic gauges and new water temp gauges
New
cold ends 1.50
New
boost pump and hydraulic motor
New
hydrostatic pump 5,000 PSI
New
hydrostatic motor 5,000 PSI
New
hydraulic hoses and fittings 5,0000 PSI
Some
of the gauges are repairable and usable
Some
Valves are repairable and usable
N2
suction plumbing repairable and usable
N2
discharge plumbing repairable and usable
Gear
Box drive is repairable and usable
Warm
end repairable and usable
TOTAL
PURCHASE PRICE EACH
$ 47,250.00
PURCHASE
PRICE IF ALL 4 ARE PURCHASED: 36,750.00 EACH
TOTAL
COST FOR AMBIENT REFURBISHING $99,750.00
This
is an estimate FIP received to refurbish the unit for Ambient use.
TOTAL
COST FOR HEAT RECOVERY REFURBISHING $141,750.00
This
is an estimate FIP received to refurbish units for Heat Recovery
use.
TERMS
AND CONDITIONS
·
The balance would be due before delivery.
·
This quotation is valid for thirty (30) days and does not include
applicable taxes.
·
Delivery 2 Weeks.
After Financial Arrangements
·
FOB XWORKS, Texas.
·
Contact: Bill Stephens
Phone 903-566-0582 Fax 775-418-0838
OES
Inc. wishes to inform you that low and high pressures are dangerous due to
force. All employees should be
trained and be aware of potential dangers associated to pressure.
OES Inc. recommends that all hoses and lines be tied off at all times
and never exceed maximum operating pressure.
Equipment
is also subject to normal wear and tear, and should be routinely inspected and
repaired on regular intervals. Failure
to operate system with correct equipment properly with trained personnel who
perform continual inspections may result in serious injury or death. |
